Other than Windows update installing the wrong Intel driver everything has worked fine this way. Set everything up as I wanted then turned on the motherboard graphics to always on. Then installed the GTX560 turning off the on board display. When I first assembled the PC I used the motherboard graphics for initial Windows install etc using all the Gigabyte discs. Motherboard bios is set for the graphics to be always on. I have the desktop extended over displays 1 and 2. I have it connected to the VT2300LED as it is closer to the PC for the length of VGA cable I had !!! Displays 1 and 2 are on the GTX560 and display 3 on the motherboard. This arrangement works great as well as VGA from motherboard to the primary Dell. VGA port of the motherboard goes to the VT2300LED monitor used by the SParkHD for preview. This monitor is shared with my mail and general use PC. Setup is Primary monitor is HDMI from the GTX560, secondary is VGA shared from a KVM switch again from the VGA adapter( on the DVI connector of the GTX560 ). Once you do it a couple of times, it is very easy. ![]() You will have to reset everything each time you install a new driver. The drawback to this is if you update your driver. Cubase 11 pro full with all its contents (groves agent, Halion sonic 3,4,5,6. This way it can remain connected with out having to have a third monitor or having to use the Intel graphics for visuals. If you have a 4k monitor I would encourage enabling the hidpi features. My monitor opens to the digital choice before an analog source. is Nvidia Secondary-digital.this is an 'extend desktop monitor'ģ is Intel-analog.this is also an 'extend desktop monitor' So when the system comes up and you go into personalize, you will see 3 monitors. I have this connected by way of an analog connection to my secondary monitors vga port. Keep in mind that auto is not the preferred choice. Now I went back into the bios and reactivated my onboard graphics. Right click the desktop and choose personalize. ![]() This was also confirmed within the screen resolution portion of the desktop panel. I then installed a driver that is compliant with my older GTX285 and set it up to run both the Primary and Secondary as a digital connection. Instead of using The Nvidia on the primary and the Intel on the secondary I completey gutted the drivers for both and shut off the quicksync feed in the bios. ![]() I recently tried a new setup for my quicksync monitors.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |